Nov 14, 2013
07:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 14, 2013
07:45 AM
I ran into a problem which I cannot reproduce.
When setting a pin to Open Drain Low (ODL), I could not get the pin
to take a StdCPU setting simultaneously. The only way I could
get it to take ODL was to set pin to a global out buss (I was working on
an output pin) rather than StdCPU..
After exiting Designer, and re-entry, it now allows me to set ODL pin to StdCPU,
and cannot reproduce error.
Ghosts.
Regards, Dana.
0 Replies