- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, when i used for the first time a cy8ckit-001, i could see selftest.hex ran in kit just with power connection, but, since i started to use the miniprog, i can't more to ran again the selftest.hex file or any other program with sucess without the miniprog plugged. If i unplug the miniprog, the program stop the function, and when i pressing the reset button, are displayed black squares in first line. Someone Knows in what cam i wrong?
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Check the power settings by checking all your jumpers on the -001 board. Compare with the initial settings in your handbook.
Depending on how old your board is check this www.cypress.com/
How was your miniprog3 configured (power, reset mode)?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All the initial connections in kit are ok, and i tried using Reset and Power cycle modes with autodetection off, and it behaved the same way before. I have doubts about the programming modes. When can i use each one?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Case solved.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please share your knowledge with us, how did you solve your problem?
Bob