pin states during reset

[Anonymous]

 Do all of the pins of the PSOC go hi-z when the device is held in reset? I have code that uses the UART to communicate to a second device. I would like to hold the PSOC in reset so I can have a separate device communicate on the line.

[Bob_Marlowe]

Would it not be easier to program the pins as high-z when needed?

   

Have a look here to find more explanation of boot process: www.cypress.com/

   

The power-on/reset state of a pin can be programmed using the "Reset"-tab in the pin configuration.

       

Bob

[ETRO_SSN583]

Some useful reference material -

               

http://www.cypress.com/?rID=57571     AN72382

           

Regards, Dana.