- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello All,
I have a simple application and on a CY8C4145 and I have placed some pins as input connected to some as output and a TCPWM component.
The issue it's that on P1.2 - TCPWM3:P I am getting some incorrect signals. Pin P1.2 it's tied to a inpout pin (see image) but looks like some other procedure ti's outputting some values there.
Does anybody has any ideea how it's configured this pin ?
Another question : on Creator's Component Catalogue there are 2 almost simiar Timer Counter TCPWM. One has a pictogram like a tree and the other one like a romb . What would be the difference betweend them ?
Kind Regards,
Daniel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you in a pioneer board ? If so look at its schematic to see which pins
are being used at the board level.
Consider posting your project for forum to take a look at it -
"File"
“Archive Project”
Use Internet Explorer or Firefox to post, Chrome does not seem to work.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please disregard my request. I have found out that I had a problem on ground plane and this was messing up the IC in certain conditions.
Kind REgards,
DAniel