Anonymous
Not applicable
Jan 27, 2014
09:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 27, 2014
09:49 AM
I want to connect a speaker of a buzzer as output. So that the speaker can produce sound.
The only requirment is that I want to control the frequency of sound produced, is there any simplest way to set up?
1 Reply
Jan 27, 2014
09:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 27, 2014
09:56 AM
Yes, use a timer, and APIs to set/ change its period.
Also if using voice coil speaker, use clamp diodes on pin, or
better yet use a single transistor buffer with a clamp on speaker.
If you don't you will get transients on pin and blow up the part.
If you use latter, transistor, limit its base current with an R, same
for collector in series with speaker.
Regards, Dana.