- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have 2 cards with PSOC 5LP, one is the freeSOC another is PSOC 4 Pioneer kit (programmer part)
I tried to connect both psoc chips with my J-Link v8 ( Vtarget RST SWO SWCLK SWV are connected),
but none of them are identified.(In Jlink Commander and IAR)
When I connect it to freeSOC, I cutted the wires from the on board programmer.
however, when I connect the psoc 4 device it can be recongnized as ARM Cortex-M0 correctly.
My Jlink works fine with the chips from other manufacturers and updated to the lastest firmware.
Any other persons have this problem?
Any solutions?
Thanks
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Not sure if this is still relevant -
http://www.segger.com/jlink-software.html
http://www.segger.com/jlink-ide-integration.html
http://www.cypress.com/?app=forum&id=2492&rID=89011
Regards, Dana.