keil:compiling error of FX2 to extsync FIFO example code

[Anonymous]

 hello, i am trying to build the example firmware(FX2 to extsync FIFO) that came with application note AN66806,i opened the 'uv2 file in keil software and tried to compile but it says "user command terminated:exit code 4".

   

i want to change the gpif waveform of that example so that i can burn new hex code to cy7c68.

   

Thanks.

[Anonymous]

 And when i tried directly dumping hex file provided ,in device manager it is coming as unknown device,but when i tried bulkloop hex file,in control centre i can see the device.

       

Thanks

[Anonymous]

Hi Abhilash,

   

Please try to download once again from the website http://www.cypress.com/?rID=12937 and try with that firmware. may I know the VID/PID of the device after programming the device (please check it in the device manager). If you are getting the proper VID/PID, then manualy bind  to drivers.

       

Regards,

   

Vikas.

[Anonymous]

 hi vikas,i am getting unknown device in the device manager.i am using 64 bit windows 7.

   

Thanks

[Anonymous]

 Hi Abhilash,

       

Please try with the attached hex file. Are you using the DVK or custom board?

       

Regards,

   

Vikas.