- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Moderators, please let me know if there is a more appropriate place to post this question:
I need to create some firmware for a project and realizing that I will not finish myself. It involves:
Free RTOS
Temperature measurement and PID Control
Counting pulses and measuring frequesncy from same
Several digital imputs
Several Digital outputs
PWM
Several cases structures (state machine)
Stepper motors (with drivers so only pulses from PSoC)
Future: 4.3" display with touch screen and Bluetooth to Android
This would be a paid project and could start right away. It would be great if you were in Seattle but in the end it really does not matter.
Processor is PSoC 4 (pioneer kit) or PSoC 5.
Thanks,
Bill
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Take a look at the design partner program -
http://www.cypress.com/?id=1088&source=support
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, I looked here and contacted a few of the partners. Did not find anyone that could do the project. So I wanted to ask the community if there was someone that might want to do it in their "spare time".
Any other suggestions to find a PSoC developer? I really want to use the PSoC platform but it is turning out to be difficult to find someone that can develop firmware for this.
Bill
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm quite sure that your request of RTOS on a pioneer board and the modules you will implement will be too tough. Better start on a PSoC5 and when prototype is ready try to shrink to PSoc4 if possible.
Programming & testing a PID is rather time-consuming
What is your estmated manpower needed?
What is your timeline?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Another possibility would be to call local Cypress Regional Sales Manager, and/or
the Field Applications Engineer, and ask them if there is any local consulting company
they would recommend.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Dana,
I have tried the Engineers but not the sales managers. I will look this up today. Thanks.
Bill
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob,
Thanks for the input. I have Free RTOS on the PSoC 4 now but have not tried to load the TFT library. I can Tune the PID pretty quickly since I have done several similar systems. But yes, it can be a bear if you are just starting on a new system.
I was just planning to pick up some PSoC 5 boards (FreeSoC version). Mostly because of the High resolution ADC Maybe enought room for the TFT also?
Bill
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The $99 development kit for PSoC5 (get your kicks here: www.cypress.com/ ) uses the largest chip availlable and it has got all you may need: ADC with 20bit resolution, fast SARs, lots of resources, PLD-logic design, HDL definable logic (if you'd like), 24 DataPath UDBs with each a programmable ALU and 2 FIFOs, USB-based debugging capabilities as breakpoints, variable inspection and call-stack analyze.
Bob