Anonymous
Not applicable
Mar 03, 2014
08:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 03, 2014
08:17 AM
I am trying to enter the PSoC 4 CY8CKit-049 4xxx Prototyping Kit as a part in my Eagle library. Where can I find the connector location dimensions? Especially the bootloader connector.
Thanks,
Doug
3 Replies
Mar 03, 2014
08:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 03, 2014
08:33 AM
The gerbers are not there on site, so I recommend you file a CASE -
To file a tech case -
“Support”
“Technical Support”
“Create a MyCase”
Regards, Dana
Aug 15, 2016
12:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 15, 2016
12:55 AM
Hello, i had the same case myself did you manage to get an eagle lub or component? If yes would youbplease share it thank youbin advanced☺
Aug 15, 2016
01:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 15, 2016
01:48 AM
The larger part remaining when you snap off the kitprog is a standard DIL format. Only the connection for the programming interface (kitprog, miniprog3) at the small side is unconventional and should be inserted by hand when needed.
Bob