- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to use UART v2.30 at CY8C4245 TX at PIN 4.1
I get 'Tx_1(0)' cannot be placed at P4[1]. P4 cannot be used for routed connections.
What's wrong ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Look at TRM, dedicated pin limitations.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
These are the dedicated pions, meaning e.g. the fixed-function SPI component can use only certain pins. But UART is not in here. The hint you are looking for is in the architecture TRM, part 7.17:
Port 4 does not have a dedicated port-adapter (Port Adapter Block on page 161). Therefore, none of the port 4 pins can be routed through the DSI.
hli
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
UART is part of the SCB, so makes one wonder if table incomplete. You raised indirectly
an interesting question. I will file a CASE on this.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I ran into similar problems - but the UART-SCB(!) can be connected to P4.0/P4.1.
However, on PSoC you've to be patient with the pin settings for other components. In my case I ran into trouble because of different input level thresholds. So, if you upload your project I can take a look into it.
Regards,
Ralf