- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have posted a similar post in oher forum and then saw this forum was more appropriate.
I am new to PSOC. Over the last few years my company has been using Microchip (we use the 32 bit). Recently the lead times have jumped to 20 weeks and we are considering swithing processors.
One aspect is that we need to enable our clients to update firmware in the field. I note the Bootloedr Host built into Creator but we need a serial UART or USB Bootloder that is stand-alone and we can use our own branding on screen.
Does anyone know of a suitable host source we could use with VB.Net (or C# etc) that enables us to add out logo etc and provide this stand-alone toool to our clients if they need to update firmware?
Thanks
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
These might be of assistance as well -
http://www.cypress.com/?rID=50230 AN68272 UART BL
http://www.cypress.com/?rID=41002 AN60317 I2C BL
http://www.cypress.com/?rID=57561 AN73503 USB HID BL
http://www.cypress.com/?rID=56014 PSoC® 3, PSoC 4, and PSoC 5LP Introduction To Bootloaders
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Note this ap note has a GUI ap and discusses customization -
http://www.cypress.com/?rID=57561 AN73503 USB HID BL
Regards, Dana.