- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I know that if I have not assign any pin in my psoc creator project, creator will automatically assign them to suitable pins available.
I created a project in which Vddio2 = 3.3V and all other voltage = 5V. I want to know that is there any way to ensure that "PSoC creator doesn't assign any pins to 3.3v bank of psoc" ? I will manualy assign pins to 3.3v bank.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Creator does not auto assign Vddio pins, they are fixed pinout. However you have
to tell Creator what what Vddio you are going to use for each Vddio domain, thats
done in the .cydwr tab of Creator.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@dana: Creator does automatic assignment - otherwise no project would compile without assigning all pins first. But the order seems to follow a heuristic (e.g. LCD component go to port 2 IIRC). There is no real way to limit this assignment. If yu have special restrictions, its best to assign all pins manually. There is a Creator extension (by keez if my memory serves me right) that could derive the right pin from how the pin component is named.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@hli, my earlier statement -
Creator does not auto assign Vddio pins, they are fixed pinout.
I stand by.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The question is:
I want to know that is there any way to ensure that "PSoC creator doesn't assign any pins to 3.3v bank of psoc" ? I will manualy assign pins to 3.3v bank.
It is not the VDDIO ins.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am not sure if there is a way to stop creator to assignment pins according to different VDDio value. I did it manually.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, Creator does not allow that.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HL, I did misread that question. There is no auto placment to
a Vddio level in Creator, you would have to do that manually,
paying attention to route specific constraints for some functions.
Regards, Dana.