Creator Enhancement

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
ETRO_SSN583
Level 9
Level 9
250 likes received 100 sign-ins 5 likes given

It would be welcome when Creator uses a module that requires

   

assigned pins, like LCD, that the tool, or datasheet, defines what

   

settings are used on the pins. In order to see this now one looks

   

into auto generated code, usually the Start(), and wades thru code

   

trying to figure out how the pins were set up. It cannot be seen in pin

   

view in *.cydwr tab.

   

 

   

I think I2C also another example of this problem.

   

 

   

Project datasheet like created in PSOC Designer ?

   

 

   

Regards, Dana.

0 Likes
3 Replies
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

I can support that request and extend the requirements:

   

A customer had to review a board that led into a re-assigning of two pins. Since both versions of the pcb where out in the field the updating became a bit tough although the PSoC "knew" on which board it was seated (versioning). Something like a "Dynamic Associated Pin" like in the Software Transmit UART could have helped him out.

   

Using different development kits all the time and pcb's in a prototype stage with LEDs and switches on different pins doesn't make life easy. I would be glad about some help to build a dependancy between a pin-assignment and a project source.

   

 

   

Bob

0 Likes
ETRO_SSN583
Level 9
Level 9
250 likes received 100 sign-ins 5 likes given

Actually a further request is that a sortable "view" of pins in table form where all key

   

pin parameters listed for each pin.

   

 

   

Regards, Dana.

0 Likes
RobynW
Employee
Employee
5 likes given First comment on blog 10 likes received

I've passed the feedback onto the development team. 

   

-Robyn

0 Likes