- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I try make the board of this Kit, but all times I get problem to write ISSP on board
I try use only minimal components to write ISSP to test but I don´t know what is this configuration,
I try
1 - CY8CPLC20 (I have CY8CPLC10 and try with both)
1 - 32.768Khz Crystal
2 - 22pf 0603 CAP of the crystal connected to pull-up
6 - Jumperto to connect:
1 - Power over PSoC MiniProg (Used)
2 - Reste over PSoC MiniProg (Used)
3 - Connect Interrupt (not used)
4 - SCL Pull Up (Not Used)
5 - Connect 32.786Khz Crystal pads (not used)*
6 - SDA Pull Up (Not Used)
*I don´t know why, but the board have this option, maybe is because have a 24MHZ crystal connected on external crystal pin of CY8CPLC20/10
I try write with power cicle and reset, using power of PSoC MiniProg and don't have sucess on both process,
the msg of Programer is
| FAILED! Can not Acquire Device! Please verify the device connection to the Programmer
Please, check the following items:
- the connection between the programmer and the PSoC;
- the correct programming protocol is selected;
- the correct connector option is selected.
I don´t know what I want to do to active write by ISSP, I have 3 board assembled with all components and all no make this write program, now I try it on one board(picture added) and I don´t know what is happining with this
sorry my english pls,
Reinaldo,
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I cannot find CY2373, can you provide a link to this kit ?
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I see you have a thread going on here -
http://www.cypress.com/?app=forum&id=2232&rID=99675
so will not post here further.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content