- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi all,
how can I stop PSoc 4 Pioneer kit from Creator software?
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just by setting a "Breakpoint". In Creator right-click on the line where you want to stop and select "Insert Breakpoint".
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Alternatively you may click into the column where the brown ball for the breakpoint occured.
There is a breakpoint window where you can see all your breakpoints you set.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You trying to put PSOC to low power state, like sleep ?
See this -
http://www.cypress.com/?rID=78797 AN86233 PSOC 4 Sleep
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Alternatively you can place a statement in code like -
while( 1 ) { }
and it will stop executing further code. If you supply while loop
with a test, like read a pin, you can escape the infinite loop
while( 1 ) performs.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi all,
first thanks all for quick suggestions
actualy I was thinking how to stop psoc4 pioneer kit from
execution of code stop it with debugger, not just unplug the USB
cable from the kit ?
thanks in advance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Since (usually) your embedded project does not write to a disk or another storage device you may unplug it anytime from power supply.
Bob