- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all.
when I program my project to the PSOC 5 and try to debug, I get this meesage:
"unable to start new debug session. the PSoC's Bus Clock must be at least 3x the speed of the device that is communicating with it."
I tried to set the clocks in order to fix this issue but I get this message over and over again.
what should I exactly do in order to fix it?
thanks in advance,
Itamar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Consider posting your project, makes life easier to troubleshoot.
“File” Creator
“Create Workspace Bundle”
Use Firefox or IE, not chrome to post.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you tell us what exactly your equipment is? Which board you use, using a MiniProg3? Can you post your complete project, so that we all can have a look at all of your settings? To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file (do NOT use chrome, that still may not work).
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There is a clock speed setting for your miniprog3. I can't remember exactly where it is and I have no acess to my desktop now. Sorry. Change it to a lower speed should help.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Under "Debug -> Select Debug Target" you find the dialog. Se the frequency to 1.6MHz. The other settings reflect my personal settings which must not be the same as yours, since I debug a CY8CKit-049-42xx
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content