- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
While trying to flash my dev kit, my computer shut down.
I tried resetting the device using the the boot pust button with the Reset push button.
And then tried to recover the device.
I see the following in the console.
Recovering platform ...
**** Recovery failed - retry ****
Detecting device...
Device found
Downloading application...
****Download failed - Press the reset button on the device and retry ****
Any ideas on how I can proceed to flash the dev kit again.
Solved! Go to Solution.
- Labels:
-
FlashEEPROM
-
SDK 2.X
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you change your application's make target to include UART=COMx and change download to recover? This is what recovering with hello_sensor would look like when using COM42:
hello_sensor-BCM920736TAG_Q32 UART=COM42 recover
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you try the Recovery procedure shown in Appendix E of the Quick Start Guide?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried the procedure in Appendix E, which is using the Boot ROM button with the Reset button.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you change your application's make target to include UART=COMx and change download to recover? This is what recovering with hello_sensor would look like when using COM42:
hello_sensor-BCM920736TAG_Q32 UART=COM42 recover
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This worked thanks!