- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
In my application I am having an UART and it malfunctions, seems data get abuse after the system wakes up from sleep.
I am setting the UART to sleep before getting the device to Sleep mode and let it wake up after PSoC gets up from sleep and when UART communication is needed. Can somebody kindly advice on where I am doing wrong?
Thnaks in advance.
Anuradha
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There are some calls for the clocks before and after sleep-mode, did you use them, too?
Can you post your complete project, so that we all can have a look at all of your settings? To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file (do NOT use chrome, that still may not work).
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Bob,
Thanks for replying.
The basic steps am following are as follows.
Source file attached for clarity.
////////////////////////////////////////////////////////////////////////////
/* ========================================
*
* Copyright YOUR COMPANY, THE YEAR
* All Rights Reserved
* UNPUBLISHED, LICENSED SOFTWARE.
*
* CONFIDENTIAL AND PROPRIETARY INFORMATION
* WHICH IS THE PROPERTY OF your company.
*
* ========================================
*/
int main()
{
/* Place your initialization/startup code here (e.g. MyInst_Start()) */
int r1;
// Timer1_ISR_Start();
// Timer_1_Start();
UART_1_Start(); // Initializes and enable UART
CyGlobalIntEnable; // Enable global interrupts.
for(;;)
{
/* Place your application code here. */
UART_1_Sleep();
CyPmSaveClocks();
Pin_LED_Write(0);
CyPmSleep(PM_SLEEP_TIME_CTW_4MS, PM_SLEEP_SRC_CTW);
CyPmReadStatus(CY_PM_CTW_INT);
Pin_LED_Write(1);
CyPmRestoreClocks();
UART_1_Wakeup();
SendPackets(); // sends data packets on USART
CyDelay(10); // 100 sps needed 10 ms delay
}
}
//////////////////////////////////////////////////////////////////////////////////////////////////////////
Thanks.
-Anuradha
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Anuradha,
Please let us know if your issues are resolved. If not please attach the complete project. I would like to know what is done inside the function SendPackets().
Cheers,
Hima
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@HIMA, do you think the original poster is still watching this
thread after 4 months of no response ?
Regards, Dana.