-
1. Re: PSOC Creator 3.0 rubber banding driving me nuts...
user_1377889 Dec 8, 2014 3:13 PM (in response to william.dreschel)Welcome in the forum and in the obvously very exciting world of rubber-banding
There are two different solutions to that issue.
On both your hands touch your thumb lightly with your index finger and say ommmmmmmmmmmmmmmmm,
Or wait for Creator 3.1, a beta is already out and rubber banding is improved.
Bob ;-)
-
2. Re: PSOC Creator 3.0 rubber banding driving me nuts...
william.dreschel Dec 8, 2014 3:41 PM (in response to william.dreschel)Thanks Bob. I am downloading 3.1 right now. I will post again if I see any improvement in my BP.
Bill
-
3. Re: PSOC Creator 3.0 rubber banding driving me nuts...
user_1377889 Dec 8, 2014 3:49 PM (in response to william.dreschel)Bill,
but watch it! It is a beta release.
Bob
-
4. Re: PSOC Creator 3.0 rubber banding driving me nuts...
william.dreschel Dec 8, 2014 4:19 PM (in response to william.dreschel)Creator 3.1 did not take care of it. BP still high.
Can't move an inverter without all kinds of weirdness.
The strange thing is, I can move an OR gate without a problem! The leading trace shrinks and the following traces expand.
In either 3.0 or 3.1. If it has two inputs, no problem.
The inverter on the other hand is just a mess to rubber band.
BUT if I can grab one whole trace on one side of an inverter and move the group, that also seems to work by shrinking the leading trace.
Is there a bug-report I can post this to?
Bill
-
5. Re: PSOC Creator 3.0 rubber banding driving me nuts...
user_14586677 Dec 8, 2014 5:41 PM (in response to william.dreschel)File a CASE -
To create a technical or issue case at Cypress -
“Support”
“Technical Support”
“Create a Case”
You have to be registered on Cypress web site first.
Regards, Dana.
-
6. Re: PSOC Creator 3.0 rubber banding driving me nuts...
user_1377889 Dec 9, 2014 12:16 PM (in response to william.dreschel)So last chance is to follow plan B, the Ommmmmhhhh version until Creator 3.2 comes.
Bob