Attachments are accessible only for community members.
Anonymous
Not applicable
Nov 11, 2014
04:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2014
04:19 AM
Could someone check the attached project which is for UART Bootloader. Once the bootlodable receives the command from PC (or something trigger for reboot) , it calls Bootlodable_1_Load() to accept commands from UART bootloader host. However the bootloader does not accept anything and freezes. My development environment is PSoC Creator 3.0 SP2 and both components are 1.20. Your any advice will be appreciated. Thanks in advance, Shuichi
Labels
- Labels:
-
PSoC 3
3 Replies
Nov 11, 2014
04:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2014
04:56 AM
Not sure if these would help -
http://www.cypress.com/?rID=50230 AN68272 UART BL PSOC 3, 4, 5LP
http://www.cypress.com/?rID=56014 PSoC® 3, PSoC 4, and PSoC 5LP Introduction To Bootloaders
Regards, Dana.
Nov 11, 2014
06:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2014
06:23 AM
I would try to enable the global interrrupts as is done in the examples.
CyGlobalIntEnable;
Bob
Anonymous
Not applicable
Nov 11, 2014
09:26 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2014
09:26 PM
Thanks for your advice, all. Finally I have succeeded the bootloader runs well. I'm not sure the reason of defect exactly , but something lots of tries such as component updates or rebuilds from scratch might be effective.