- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I work with this example, and tried the Hi-pass and low-pass
filters (and other filters) but unfortunately the result are not
corralted to the filter.
The input I use is with the generator of sine wave between 0.3-5 khz
And, the output is a sine wave, but with wrong amtipudue and phase.
I try to play with the gain, and with coefficents of the filter but with no succes.
Attach - exmpale:
Input - sine wave of 800 hz.
Output - not responding to the filter
Please your advice...
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I cannot tell what goes wrong, what you expect to happen and what does not happen, too few input. Can you post your complete project together with a more detailled description what you expect to see and what you actually get?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To post the project -
“File” Creator
“Create Workspace Bundle”
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There is a mismatch between the sps of the ADC (48Ksps) and the definition for the filter (10ksps). I would suggest you to choose the same rate for both (10ksps) to see a more correct result.
Bob