Anonymous
Not applicable
Jan 22, 2015
04:13 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 22, 2015
04:13 PM
Hello,
I want to use FX2LP in 8 Bit slave FIFO mode but using vendor command I want to change I/O values then return to slave FIFO mode.
During vendor command operation PD4 value is set to '0' by firmware but when return to slave FIFO mode it could not retain its value and becomes '1'. Is there a way to retain value as '0' while operating in slave FIFO mode.
Thanks..
1 Reply
Anonymous
Not applicable
Jan 22, 2015
09:53 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 22, 2015
09:53 PM
Hi,
For just toglling the I/Os what is the need of changing the slave fifo and port mode.In slave FIFO mode also you can drive the GPIO.
Regards,
Vikas