- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
I am looking to have my PC enumerate two separate USB UART ports using Cypress' PSoC 5LP development board. I haven't found much documentation on how I can achieve this using a single USBFS block, and using two separate USBFS blocks on Creator 3.0 gives be this error. I was hoping someone could point me in a direction.
Many thanks,
G
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am afraid that within the PSoC5 chip is only one USB hardware availlable. On the development kit is a second USB port which is made with a separate CY7C68013A chip.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bob,
Thanks for the reply. Another thread discussed this but a solution wasn't offered: http://www.cypress.com/?app=forum&id=2492&rID=82498.
Is being able to access multiple CDC COM ports over a single USB port within the realm of possibilities?
-Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Last chance to answer that question is to create a MyCase and get help from Cypress. On top of this page Support & Community -> Technical support -> Create a MyCase.
Bob