Anonymous
Not applicable
Feb 05, 2015
11:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 05, 2015
11:36 AM
Hi,
I am working on the psoc 5LP and unfortunately when I try to program to the device the creator doesn recognize the miniprog
it worked well until now and the device is defined correctly
what can I do?
Please your kind help
Labels
- Labels:
-
PSoC 5LP
2 Replies
Feb 05, 2015
12:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 05, 2015
12:06 PM
Re-boot your PC, plug-in the MiniProg3 with no target, start Creator, then select "Debug -> Select Debug Target" and watch for the MiniProg showing up in the list.
Then plug-in your target board and check whether it is shown.
Bob
Feb 05, 2015
06:59 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 05, 2015
06:59 PM
Sometimes simply unplugging Miniprog from USB and replugging
will get everything going again.
Regards, Dana.