- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have just started using this product and I have a question, I am using version 2.1.0 of the SDK
I am trying to set the baud rate of the puart to 19200, I have tried the following
const BLE_PROFILE_PUART_CFG hello_sensor_puart_cfg =
{
/*.baudrate =*/ 19200, //115200,
/*.txpin =*/ GPIO_PIN_UART_TX,
/*.rxpin =*/ GPIO_PIN_UART_RX,
};
Does not work, baud rate is set to the default of 115200
Tried
puart_cfg->baudrate = 9600;
puart_selectUartPads(puart_cfg->rxpin, puart_cfg->txpin, 0x00, 0x00);
puart_init();
Does not work, baud rate is set to the default of 115200.
The puart is operational as I can send and received characters without any errors but only at 115200.
Any help would be greatly appreciated.
Solved! Go to Solution.
- Labels:
-
Peripherhal UART
-
SDK 2.X
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The BCM2073x includes two sets of APIs that are available for the application: the low-level driver API and the high-level profile API.
I know that there is a code snippet within the HW USer's Manual that shows how to initialize the peripheral UART using the low-level driver API available in the WICED SDK: WICED Smart™ Hardware Interfaces
You might also want to take a look at the code snippet here that one of our developers provided to another user: Re: Long Data from UART
This includes some other functionalit you may/may not require, but it works and shows the PUART operating at 9600, which is the lowest rate available for the PUART.
Once you have this code working, you can adjust the rate up to 19200 and see if you run into any issues.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you tried:
puart_init(); |
puart_setBaudrate(0,0,19200);
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks to all who replied.....the solution now works.