- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I followed AN75779 to implement an 8 bit interface UVC. I have a card with a fx3 and a fpga. With fpga, I generate signals lv, fv and pixels (1920 * 2 * 1080 / Y = counter; U / V = 0x80). Everything works and I have a grey-scale image. But when I want to switch to 16-bit interface, it does not work. However, I modified the GPIF with a 16-bit bus and a limit of 8183 meter. Obviously, the state machine is stuck in a state PARTIAL/FULL_BUFF_IN_SC0/1. Any idea?
Thank you!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @rolic_4206696,
Kindly make sure that the image sensor outputs the data in 16 bits.
Best Regards,
AliAsgar
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I got the same issue.
Do you have the solution for this?
Thanks~
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I got the same issue, and I would like to ask whether you got any solution to fix it?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I got the same issue, and I would like to ask whether you got any solution to fix it?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @rolic_4206696,
Kindly make sure that the image sensor outputs the data in 16 bits.
Best Regards,
AliAsgar