SW3 on the CY8CKIT-050 PSoC 5LP

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
lock attach
Attachments are accessible only for community members.
Anonymous
Not applicable
        Hello!!! I am a super noob when it comes to PSoC. I am working to get the Filter_ADC_VDAC_poll example project running on my PSoC 5LP. It says in the documentation that I need to "Set SW3 to 5V and leave the rest of the board at default configuration." I have found where it says sw3 on the board but it isn't a switch, it is a button. What do I need to do on the 5LP so that I can configure this kit correctly? Thanks for you help!!!   
0 Likes
3 Replies
ETRO_SSN583
Level 9
Level 9
250 likes received 100 sign-ins 5 likes given

SW3 applies only to the CY8CKIT-001. For the other

   

kits just insure the power jumpers set up to 5V.

   

 

   

   

 

   

Regards, Dana.

0 Likes
Anonymous
Not applicable
        Thanks Dana, I finally found the PSoC 5 Development Kit Guide. I don't know why it was so hard to find. I see where you are pulling from. Thanks!!!   
0 Likes
ETRO_SSN583
Level 9
Level 9
250 likes received 100 sign-ins 5 likes given

Glad to have been of assistance.

   

 

   

Regards, Dana.

0 Likes