- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Start your update managers and update your Creator software to service pack 2.
Happy coding
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Noteworthy updates I have seen so far:
- support for the (upcoming) EZ-BLE PRoC modules (just 10x10mm for a complete PRoC module!)
- the SAR ADC now should reach the 1Msps, since the conversion time has been reduced to 16 clock cycles (when using Vref)
- some important bugfixes for the SARSEQ ADC (e.g. wrong results for the last scanned channel)
- bugfixes to the SPI components
- bugfixes to UART (related to interruption of PutChar)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Even more -
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
And this -
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Updating uninstalled PSoC Programmer, and now it won't reinstall, even from a fresh download. Creator whines about it being missing. I'm on Win 7 Pro.
Update: PSoC Programmer was still present in the Windows Control Panel Add/Remove Programs, so I uninstalled it there too. The download then installed correctly and Creator stopped whining.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After the SP2 update and updating components, I cannot "Generate Application". It gets stuck on "Elaborating Design...". Anyone else experiencing this?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No error like yours yet. Suggesting to create a MyCase on that topic with project attached.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Appears that it was a bad update to the SAR ADC. I deleted the component and readded and it works fine now.
Correction: The 16 to 18 cycle change to the SAR ADC ment I needed to adjust my conversion rate. I adjusted it so it was just above the minimum clock frequency. It didn't like that apparantly. If I bump the conversion rate a bit higher and have more headroom on the clock frequency, it builds fine.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content