- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good morning all,
Why the cypress (cy7c68013A - 56/100/128) which is used in xilinx platform cable usb/usb ii is detected by cypress control center software?
In order to detect this in control center what we should do?
Regards
Vimala
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
If the device binds with cypress drivers then only device can be seen in control centre.
If your device is using custom drviers or non HID/mass storage cannot be detected in control centre.
Try to manually bind your device with cypress drviers
Regards,
Vikas
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
If the device binds with cypress drivers then only device can be seen in control centre.
If your device is using custom drviers or non HID/mass storage cannot be detected in control centre.
Try to manually bind your device with cypress drviers
Regards,
Vikas