FX3 Pin D2 (I2S_SD ) power up value

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

 Hi all,

   

 

   

I have a EZ-USB FX3 DVK, when I turned on the board with the USB Boot mode, I observed that the pin D2(I2S_SD) is toggling with around 400KHz. I need to know why this pin alone is toggling but other I2S pins are at Low state. (I did not loaded the FX3 any Firmwares, FX3 USB Bootloader firmware residing in the BootROM only loaded).

   

Please help me, If there is any settings to make this pin to be at low during startup. Or is it possible to change the BootROM present in the FX3 ROM.

   

 

   

Thanks,

   

KCNGP

0 Likes
3 Replies
Anonymous
Not applicable

 Hi Gokul,

   

It is not possible to change the internal boot ROM Code.

   

I will check this internally and update you.

   

Regards,

   

-Madhu Sudhan

0 Likes
Anonymous
Not applicable

Hi,

   

When I tested, i could not notice any toglling on I2S_SD pin. It was low as expected.

   

Regards,

   

- Madhu Sudhan 

0 Likes
Anonymous
Not applicable

Hi,

   

Same for me, I checked GPIO during reset/power-up and I2S_SD (GPIO51) behaved as specified (drive low).

   

Please find a list of GPIO values in Knowledge Base Article KBA86731 (http://www.cypress.com/?id=4&rID=91267)

   

Cordially - Frank

0 Likes