Anonymous
Not applicable
May 15, 2015
09:59 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 15, 2015
09:59 PM
Dear All Please advice to buy a Programmer to read and write FM1608-120-P 64Kb Thanks in advance
2 Replies
May 18, 2015
12:29 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 18, 2015
12:29 AM
Hello,
Just a small note that FM1608 is an obsolete device and is not recommened for new designs. The interface for FRAM is similar to non volatile memory designs and programmers which support parallel non-volatile memories can be used.
http://www.elnec.com/products/universal-programmers/beeprog2/ is one of the programmers that you can refer which supports FRAMs.
Regards,
Ajay
Anonymous
Not applicable
May 21, 2015
11:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 21, 2015
11:31 AM
Dear Thanks for the reply
Actually this is very expensive and do you have any schematic of this programmer
Please advice
Thanks
PA3040