- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you detail your application a bit more. Are you trying to bind it to Cy driver and access through a GUI? If so, did you check if it is bound properly in the device manager?
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have all of the drivers and c/h files for it, and have connected it to the desktop. But Cypress Suite USB 3.4.7 does not read it as connected, Once I finally do get it connected I want to use the button input as a joypad in windows.
Connected it, powered it up, And I get nothing in cypress.
Here are some of the files if you want to have a look
https://mega.co.nz/#!zwBinZgZ!BJZXSxP_PeLC_6K2i8-x4lIg0W9wnJixm_j_K-s8FUU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Eh, I just decided to upload a picture.
Windows detects it just fine in the device manager....but, Its not detected at all by the console.
http://i5.minus.com/iM7maSi2fZtOW.png
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
As can bee seen from the pic that you had attached, the devcie is bound using LIBUSB driver I believe. In that case, it is not expected for the device to show up in CyConsole/ Control Center. Control Center (from SuiteUSB 3.4.7) shows up devices bound to either CyUSB.sys, HID/ MSC driver.
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Why do you want the device to show up in Control Center. Please detail what you are trying to do.
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Im simply plugging it in with power going to the device.
Even after unbinding it to the libusb driver it would not work or show up as a connected device. Forgive me for being new to the lubusb, The device has always been config`d and ready to go, Never had to set it up before today.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
When you say unbinding from libusb, did you bind it to Cypress driver (cyusb.sys) ? Are trying all tehse for some experimental purpose? Please explain why you want the device to show up in Control Center?
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello
I am a technician like you and me know if you have achieved recognition as the I / O board as pad