Anonymous
Not applicable
May 31, 2015
01:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 31, 2015
01:42 PM
After a lot of Built and Program actions, once my CY8CKIT-049-4125 board haven't worked. the message after Program action is Communication port reported error "Unable to read data from the target device". Until now everything was very good. I tried to see if the board is OK and I used another board .....42xx and the message is the same. I updated the PSoC Creator3.1 to PSoc Creator3.2, the message is the same. Please, I need some support because I am in the middle of a project.
2 Replies
May 31, 2015
02:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 31, 2015
02:48 PM
Anonymous
Not applicable
May 31, 2015
03:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 31, 2015
03:45 PM
Thank you danaaknight, it seems I am in the situation(wedge) from the second http. I will try to reinstall all Cypress software. It seems for other users have worked. Thanks again.