Anonymous
Not applicable
May 26, 2015
09:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 26, 2015
09:58 AM
Can anyone tell me where the center of mass is for this module? We could determine it by trial and error when the first proto hits the surface mount line, but knowing ahead of time is so much cooler.
tc
Labels
4 Replies
May 26, 2015
11:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 26, 2015
11:15 AM
You might want to file a CASE on this -
To create a technical or issue case at Cypress -
“Support”
“Technical Support”
“Create a Case”
You have to be registered on Cypress web site first.
Regards, Dana.
Anonymous
Not applicable
May 26, 2015
11:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 26, 2015
11:36 AM
Thanks Dana. I've done that. If I get an answer, I'll post it here for anyone else who may need the same information.
tc
Anonymous
Not applicable
Jun 15, 2015
08:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2015
08:43 AM
Did you receive any info from cypress on the pick point?
Anonymous
Not applicable
Jun 15, 2015
09:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2015
09:05 AM
Only that they're waiting on a datasheet update.
tc