- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi
I want to connect my PSOC5LP board with 16*2 LCD,whether it is possible thereby i can display my analog values there.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What board do you have ?
You want the LCD to have a Hitachi / Renesas 44780 controller on it, then interface
is easy, 4 pins for data, 3 for control, one port of PSOC, one for contrast, 2 for power.
Or use the Kees component which allows general pin connection interface.
Or an I2C or SPI LCD, and you write the driver for it.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using this chipset HD44780 , http://www.tenettech.com/product/2442/16-x-2-character-lcd-display-with-backlight-jhd162a-green ,whether any example or application note availble for this interface?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Use the Character-LCD component, that will work for that kind of display.
Do you have got a Cypress development Kit (which one) or are you using your own board?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
FreeSOC 2 from sparkfun PSOC5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you look in the data sheet for the LCD component there is a connection
diagram shown. If you use Kees then the connections are flexible and
you choose what pins.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content