Anonymous
Not applicable
Jul 14, 2015
11:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 14, 2015
11:35 AM
can i interface cy8c 4000 pioneer kit with PSoC 5lp kit for using the proximity sensor in a project?
Solved! Go to Solution.
Labels
- Labels:
-
PSoC 5LP
1 Solution
Jul 14, 2015
12:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 14, 2015
12:51 PM
Or software Tx UART (TTL/CMOS levels) on 4000 side or bit banging a serial interface or parallel 4 or 8 bit interface (no component
support for that other than pins component).
You could even do it serially over the CSD A/D and DAC interface.
Regards, Dana.
3 Replies
Jul 14, 2015
11:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 14, 2015
11:47 AM
You may connect both kits via I2C.
Bob
Jul 14, 2015
12:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 14, 2015
12:51 PM
Or software Tx UART (TTL/CMOS levels) on 4000 side or bit banging a serial interface or parallel 4 or 8 bit interface (no component
support for that other than pins component).
You could even do it serially over the CSD A/D and DAC interface.
Regards, Dana.
Anonymous
Not applicable
Jul 16, 2015
11:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 16, 2015
11:01 AM
thank you all..