- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I don't know whether this is the correct forum for this question or not. If not then, i am very sorry please direct me to the appropriate forum.
I used PSOC 5LP development kit for my project. It works vey well. But i don't need all the features (e.g. breadboard, variable resistor, switches or LEDs etc). Is there any plug and play board available in PSOC 5 LP or i have to program the whole chip separately?
Any one have any idea?
Looking forward for your reply.
Regards
Awais
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you already have a look at the CY8CKIT-059? The programmer-part can be broken off, so the size shrinks a bit. All ports are connected to solder points.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you already have a look at the CY8CKIT-059? The programmer-part can be broken off, so the size shrinks a bit. All ports are connected to solder points.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yup i found it.
Looks good 🙂
Thx Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You have seen these as well -
http://www.cypress.com/blog/psoc-creator-news-and-information/new-psoc-5lp-board-powerfulboard
http://www.schmartboard.com/index.asp?page=products_dev&id=648
Regards, Dana.