Jul 23, 2015
01:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 23, 2015
01:36 PM
Hi,
I am looking for advise on of-topic subject, hoping for vast experience of forum users.
I am looking for a solution to match two packages: a driver board and LED package by installing some ID chip into LED package. So before turning on, the driver board can check that it has matched LED attached. It would be nice if some extra ~64 bytes of information could be stored it such memory, such as driving voltage, current, etc., and package size would be small as possible, maybe bodyless, with 3 legs or less (power, 1-wire/SPI and GND).
Thank you,
odissey1
Labels
- Labels:
-
PSoC 5LP
3 Replies
Jul 23, 2015
02:03 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 23, 2015
02:03 PM
Maxim makes a number of variants, here is just one of them -
http://www.maximintegrated.com/en/products/digital/memory-products/DS2401.html
Regards, Dana.
Jul 24, 2015
10:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2015
10:14 AM
Thank you.
Jul 24, 2015
05:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2015
05:31 PM
Glad to assist.
Regards, Dana.