- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have CY7C68033 on my board with 1-off Nand flash MT29F8G08ABABAWP chip. (Schematic attached.)
both are blank from Manufacturer.
I plug in the USB port in my windows7 64bit Laptop and the usb controller appears in Control Panel in other devices with hardware ID 04b4.
I guess the USB controller will be in Manufacturing mode as there is nothing in the Nand flash.
what next? where do I go from here?
where to get drivers?
any help appreciated.
thankyou.,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You can refer the Development Kit's quick start guide to proceed with your design as well. You will get all the documents, softwares, drivers from this link:
Regards,
- Madhu Sudhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have somehow managed to configure it and it appears in Windows7 as unallocated space, but cant format it with windows?
any clues?
regards,
j