Anonymous
Not applicable
Aug 27, 2015
10:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 27, 2015
10:39 AM
I am using CySmart 1.0 with a CY8CKIT-042-BLE PRoC USB Dongle.
This dongle was working previously but I think I may have accidentally erased the firmware of the PRoC whilst I was using PSoC Studio although I can't be certain. As a result it appears that it is no longer recognised by CySmart.
The COM port shows up but PuTTY cannot open the port.
I have tried flashing KitProg and the BLE Dongle hex file using PSoC programmer with no luck.
Any help much appreciated on this matter.
Labels
- Labels:
-
BLE
1 Reply
Anonymous
Not applicable
Aug 30, 2015
02:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 30, 2015
02:30 AM
I get that Error every once in a while too!
Usually if I had the computer in standby mode and didn't unplug the dongle. For me it works just to unplug and replug the dongle. Then CySmart lists the device as supported.