- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
after the upgrade to PSoC Creator 3.2 SP1 (3.2.0.6175), and PSoC Programmer 3.23.1.2145 I tried to program the device I used to program but the miniporg3 doesn't acquire the device, I tried to set on "reset" with external power, I tried "power cycle" without external power..I tried a lot of combinations, anyway before the upgrade I could program my device, but now I'm blocked, and I need to work, so it's a big problem. Before to write this topic I searched on this forum, but I couldn't find a solution..
My OS is Windows 7 Professional SP1
Could anyone help me please?
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Use Cypress Programmer and check if your MiniProg3 needs an update. Check beforehand if Cypress Programmer is up-to-date.
Perform a complete reset, switch off the PC and start anew.
Hope that helps,
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bob, thanks for reply, unfortunately I already tried all the thing you wrote.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would file a CASE in parallel with this, post your project with
the case.
To create a technical or issue case at Cypress -
www.cypress.com
“Design Support”
“Create a Support Case”
You have to be registered on Cypress web site first.
Regards, Dana.