- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I need to program a psoc-4 chip that is mounted on a PCB.
Is it possible to program the chip while it is still intact on the board using the pioneer kit?
I have access to the SWD pins, Vcc, GND and XRES as prescribed by the programming guide.
Please help!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes that is possible, there has been a hack posted here in the forum, but I cannot find it right now. Buried deeply...
Another choice could be to usa a CY8CKIT-059 prototyping kit which comes rather cheap. You may use the snap-off programmer to program any PSoC 3, 4 and 5LP chip.
Happy programming
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you have CY8CKIT-042 PSoC® 4 Pioneer Kit can modify it a bit:
http://www.cypress.com/forum/psoc-4-architecture/can-miniprog1-program-psoc-4-049-board
But Bob's advice is better.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Modified it, and it worked perfectly!
Thank you!