Hi
I am using the proximity example with the tuning tool. That worked ok until I tried to use the debugger as well. The software did not jump to the required breakpoints as the code was not compiled in by default. After running the debugger, I could not program the board again as it is not seen in the list of devices.
I rebooted the pc and reloaded the PSoC Creator software. The Pioneer board is seen and is in the devices list of the pc as the Kitprog device but the software does not see the device. So I cannot program it anymore.
Any suggestions please?
P.S. I am very new to all of this 😞
Regards
Marius
