Anonymous
Not applicable
Sep 30, 2015
12:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 30, 2015
12:31 PM
Hi,
I am using the Cypress PSoC BLE pioneer kit. I am trying to emulate the throughput example on project 24. I did not change the code downloaded from Github
I programmed the GATT Notifications Outgoing onto the PSoC board and programmed the GATT Notifications Incoming onto the USB Dongle.
I connected to both ports using Putty as per the settings mentioned in the accompanying pdf
Baud rate – 115200 bps, Data bits – 8, Stop bits – 1, Parity – None.
however I do not see any data on the terminal.
Am I missing anything ?
Thanks
Vijay
Labels
- Labels:
-
BLE
1 Reply
Anonymous
Not applicable
Oct 19, 2015
07:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 19, 2015
07:49 AM
Hi,
Please check the COM Port Settings in your device mnager and see if this matches with the settings on the Putty.
Regards,
- Madhu Sudhan