Attachments are accessible only for community members.
Oct 04, 2015
12:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 04, 2015
12:10 AM
When I measure the I2C signals with oscilloscope, I get a strange I2C signal timing sequence (attachment picture is the oscilloscope's waveform). The oscilloscope tell me the I2C master is addressing with 0x30 slave address, and following an ack. The starting sequence is also very strange. This waveform appears several seconds periodically. I can not measure my real waveform and debug the I2C interface timing sequence. I can make sure that my firmware is not controlling the I2C controller, and there is no I2C slave device's slave address is 0x30, and FX3 is the only I2C controller on my board.
Can anybody tell me why this occurring? Thank you very much!
1 Reply
Oct 04, 2015
12:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 04, 2015
12:33 AM
Sorry, the description above is incorrect. Please delete this post, thank you.