- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just discovered that Cypress has a Thermistor Calculator Component that I would like to use.
How do I add this to my Component Catalog so I can add it to my project?
I'm assuming it's allowed with BLE PRoC, since it's a software component, but maybe not since I can't get it as a component in the catalog.
Thanks
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Well, it appears that this is not an option for the PRoC BLE. I found a project with this component, copied it into my component, and it gave me an error that's it's not available for this processor.
ADD: sdb.M0059: error: Error in component: Thermistor. Component 'ThermistorCalc_v1_20' is not supported by the selected device.
So, If I have to roll my own thermistor routine, I'd like to use LOG. Can I use LOG with this part? Anyone know how? not having much luck so far.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When you mean using logarithms you just need to #include <math.h> and under project settings use the library "m".
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
MidwestPDS,
there is another custom component - "Fast thermistor calculator":
http://www.cypress.com/forum/psoc-community-components/fast-thermistor-calculator
it was tested witn PSoC4 and PSoC5LP (not with PRoC), but since it is just a software component, I do not foresee problem using it with PRoC.
odissey1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey Bob Marlowe,
I did include math.h, but can you be more specific about "under project settings use the library "m"." I searched around and didn't find a place to make this setting??? where do I make this setting please?
Thanks!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Odissey1,
Great, I'd like to try it... How can I add it to my design, it's not showing up in my component catalog.?? Is there a way to access these software components?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I was talking about
in "Creator -> Project -> Build settings -> Linker -> General -> Additional Libraries" add "m"
The cryptic name caused by: You want to use library "mlib". Since all libraries end on "lib" these characters are left out and only the "m" remains.
Bob