- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
It appears that advertisements cycle through the three channels at one message per advertising interval specified. So, if you disable two of the three advertising channels your advertising frequency is actually 3x the configured value. Is there a way to only advertise on one channel yet keep the configured rate?
Thanks,
Tom
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you enable all the three channels for advertisement, three advertising packets may be sent in an advertising event (one on each of the three enabled advertising channels). If you enable only one channel for advertisement, then the adv packet would be send once through that channel at the advertisement rate specified.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you enable all the three channels for advertisement, three advertising packets may be sent in an advertising event (one on each of the three enabled advertising channels). If you enable only one channel for advertisement, then the adv packet would be send once through that channel at the advertisement rate specified.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the reply. It seems my scan window & interval aren't configured correctly to see all of the advertisements.