- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
According to the explanation of CySysClkEcoStart(uint32 timeoutUs), timeoutUs : Timeout in microseconds. Is there any reference guide for the chip of CY8C4247LQI-BL483? Another question is, if this timeoutUs = 2ms, which usage should I choose, CySysClkEcoStart(2) or CySysClkEcoStart(2000)?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Since the timeout is expressed in µs you will need for a 2ms timeout to specify 2000.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Bob!
According to following "The timeout interval is measured based on the system frequency defined by
PSoC Creator at build time", how do I measure the timeout interval if my IMO frequency = 24MHz?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Language problem: "The timeout interval is measured based on the system frequency.." means
the interval has already been measured, you do not need to do that. Just specify your wanted time your ECO needs to start up.
Bob