Nov 05, 2015
06:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 05, 2015
06:20 AM
We made a camera using FX3.
And next step, we use GX3. then we send data from fx3 to gx3.
Finally, Sensor -> FX3 -> GX3 <-- ethernet --> PC
Is it possible?
3 Replies
Nov 05, 2015
08:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 05, 2015
08:43 AM
Hi,
This should be possible with HS host controller of FX3. Why do you use GX3 here? Is it due to the USB cable length limitation?
Thanks
Nov 10, 2015
01:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 10, 2015
01:01 AM
Yes. We wish to overcome the USB cable limitation.
Anonymous
Not applicable
Feb 14, 2016
11:05 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 14, 2016
11:05 PM
Hi,
If you just want to extend the cable, we can suggest active cable and optical cable, please refer below link for detail:
Active cable extenders - http://www.cypress.com/news/cypress-and-icron-technologies-announce-joint-interoperability-usb-30-co...
Optical cable extenders - http://investors.cypress.com/releasedetail.cfm?releaseid=855041