- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I am creating a project that will fade 9 LED/RGB into different states. ie. fading is one mode
others are patterns, flashes and etc. Do you have a suggestion as to which PSOC 3,4,5 I should use?
Not interested in PSOC 1 because it does not use creator.
Thank you 🙂
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What you need are 9 PWMs and PSoC3 and 5 are able to handle that. The PSoC5 is more modern.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you Bob...do you have a specific part in mind. The selection is huge. I would like to stay with a SOIC if possible.
Thank you again
Steve-
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob, what do you think about this device? CY8C4013SXI-411-ND
http://www.digikey.com/product-detail/en/CY8C4013SXI-411/CY8C4013SXI-411-ND/4842997
Do you think this will work?
thank you
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, you will not get 9 PWMs out of a PSoC4. I would suggest you to get a CY8CKIT-059 which has got one of the largest PSoC5. Then, when you programmed your project you will see what you actually did use and choose the smallest device (pins Flash, SRam) that fits.
Bob